• Home
• General
• Products
• Fire
• Contact
• About

• General
• LPG
• IBC
• Mining
• Petroleum

• Products
• Tanker Equipment
• Terminals And depots
• Overfill Protection

DBC80 & DBC50 Dip Cap and Adaptor

Available in 50mm and 80mm versions. The pressure relieving Dip Cap enables pressure to be released before opening the cap.

DIP ADAPTOR is bayonet type fastening with flange mount.

DIP CAP incorporates pressure relief, actuated when the cap is pressed down to twist-to-release.

DTA80 & DTA65 Dip Adaptors

DTA80 & DTA65
Standard mil spec camlock tops, through hole square flanges, skirt on bottom of 74.5mm diameter to suit standard 80mm dip tube DTS3 type.

Weld to skirt or if pop-rivetting it is essential to use steel rivets of the largest possible diameter.

Screw down on to VOH400 (which has blind tapped holes) or through bolt using fibre washer under bolt head to VOH200 series and VOH700 series.

DTA80L
Exactly as DTA80 except the square flanges are drilled and tapped instead of being holed.

DTA80-3
Exactly as above except having an integral weld-in flange for use with low profile tankers .

FTA80 & FTA65 Fill Adaptors

FTA80 & FTA65FTA80 & FTA65
Standard mil spec camlock tops, through hole flanges, skirt on bottom of 77mm diameter to suit standard 80mm fill tube FTB3 type.

FTA80L
Exactly as above except the square flanges are drilled and tapped instead of being holed.

FTA80-3
Exactly as above except having an integral weld-in flange for use with low profile tankers

Dip and Fill Tubes